Durlon® HT1000® Paste

Durlon® HT1000® Paste is a High-Temperature Sealing Compound designed to be used in conjunction with our HT1000® sheet material specifically for end-users creating a larger one-piece constructed gasket from cost-effective dovetail segments.

CONTAINER SIZES:
170 g and 90 g

SHELF LIFE:
6 months in an unopened container from the date it was packaged.

CAUTION:
(FOR INDUSTRIAL USE ONLY) Wear eye and skin protection when handling. Ventilation may be needed. Wash hands after use. Avoid contact with an open flame or other ignition sources. Keeping the compound moist will minimize airborne particles when sanding or grinding cured sealant. DO NOT reuse containers. KEEP OUT OF REACH OF CHILDREN.

WARNING:
Avoid inhaling dust or vapors. Do not get on your eyes, skin, or clothing. If swallowed, rinse your mouth, DO NOT induce vomiting, call poison control and consult a physician. Inhalation: If ventilation is poor, wear respiratory protection. If experiencing breathing problems move to fresh air and seek medical aid. If on skin: wash with lots of soap and water. If irritation or rash develops, seek medical attention. Use protective equipment as required. Always read SDS and product technical data before use.

STORAGE:
Store in a closed container in a cool, dry place (refrigerate for best shelf life). Keep away from open flames.

WARRANTY:
Triangle Fluid Controls Ltd. assumes no liability for damage caused by this product other than the purchase or replacement of this product. The responsibility for determining whether or not the product is suitable for use rest with the purchaser.

INSTRUCTIONS FOR USE:
1. Make sure gasket segments are aligned and laying flat pre-assembled. Ensure that both the gasket and flange are free of debris, oils, and grease.
2. Stir well before use. The surface should be clean and dry. Open container of HT1000® Paste and apply a thin, even layer to the dovetail portion of the gasket, using a disposable brush or putty knife, smoothing out any uneven portions. Close and tighten joints.
3. Assemble flange and tighten bolts according to gasket manufacturer’s recommendations (torque, bolt-up method, etc.).
4. HT1000® Paste will begin to cure in service. (Please refer to applicable Required Cure Time)

Industries

, , , , , ,

Durlon® HT1000® Paste is a sealing compound designed to be used in conjunction with our HT1000® sheet material specifically for end-users creating a larger one-piece constructed gasket from cost effective dovetail segments.
Solvent Mixture, Crystalline Silica, Tetraborate Pentahydrate, Aluminosilicate, Kaolin, Modified Natural Resins.
Temp. min 65°C (150°F)
Temp. max 980°C (1,800°F)
Curing Temp/Time Required 149°C (300°F)/4 hrs, 204°C (400°F)/3 hrs, 260°C (500°F)/2 hrs, 316°C (600°F)/1 hr, 371°C (700°F) or Higher/<1 hr