SPECIFICATION SHEET
January 2009

DURLON^® 9200W
Barium Sulfate Filler with Pure PTFE Resins
FILLED PTFE GASKET MATERIAL
ASTM F104: F452111-A9B5E11K6M6

DURLON^® 9200W is also used for hydrofluoric acid service at moderate concentrations and temperatures or where a barium sulfate filled PTFE gasket material is specified within a temperature range of –350°F to 520°F (-212°C to 271°C), or with pressure up to 1500 psi (10.3 MPa).  Style 9200W (granite white, branded) conforms to FDA requirements.

OXYGEN: DURLON^® 9200W has been independently tested and certified by the Federal Institute for Materials Research and Testing, Berlin (BAM) for gaseous oxygen at pressures up to 585 psi (40 bar) and temperatures up to 392°F (200ºC), and for service in liquid oxygen.  Gaskets for oxygen service can be supplied from distributor stocks, providing proper cleaning procedures for oxygen service are followed before installation.

Note: that as a class, PTFE gasket materials are not recommended in liquid oxygen services where there is THERMAL CYCLING due to thermal shock and the difference of the coefficient of expansion between PTFE and steel.

COMPOSITION:

Barium sulfate fillers are homogeneously blended with pure PTFE resins to give DURLON^® 9200W its physical and mechanical properties. Independent testing has shown the fillers in DURLON^® 9200W to be more evenly dispersed than filled PTFE with layered construction. The result is more consistent physical and mechanical properties without the voids, separation and chemical compatibility problems found in layered filled PTFE. It is suitable for use in steel flanges, will not exhibit the cold flow problems associated with virgin or generic skived PTFE or the hardness problems of some other filled PTFE products. It has excellent sealability, cuts easily and separates cleanly from flanges after use.

Note: ASTM properties based on 1/16" sheet thickness except ASTM F38, which is based on 1/32" sheet thickness. This is a general guide only and should not be the sole means of accepting or rejecting this material. The data listed here falls within the normal range of product properties but should not be used to establish specification limits nor used alone as the basis of design.

*For applications above Class 300, consult your representative.        PxT Chart
 

AVAILABLE SHEET SIZES:

Note: 60" x 120" (1.5m x 3m) sheet sizes available on special order, other custom lengths available on request.

Open PDF file of this page
 

Warning: Durlon gasket materials should never be recommended when both the temperature and the pressure are at the maximums listed.  Properties and applications shown are typical.  No application should be undertaken by anyone without independent study and evaluation for suitability. Never use more than one gasket in one flange joint, and never reuse a gasket.  Improper use or gasket selection could cause property damage and/or serious personal injury.  The data reported is a compilation of field testing, field service reports and/or in-house testing.  While the utmost care has gone into publishing the information contained herein, we assume no responsibility for errors.  The information and specifications  contained in this website are subject to change without notice. This revision cancels and obsoletes all previous editions.

 
Home

®Registered trademark Triangle Fluid Control Ltd.                        Terms of Use             ©2002-2011, Gasket Resources Inc., All Rights Reserved